Table of Contents
Advertisement
Manual
Note: If the IP address is changed then the IP address required for WebGUI access will also change accordingly. If
the new address is assigned via "Auto IP" or "DHCP" it might be necessary to temporarily disable the Video Link
between the Receiver and Transmitter in order to display the units' new IP addresses on the Receiver's HDMI output.
Press and hold the LINK button for 3 seconds to enable or disable the Video Link.
•
Channel Setup
Use the dropdown to select the broadcast channel for the Transmitter. All Receivers on the local network that are set
to the same channel will receive video from this Transmitter. The available channel range is from 0 to 255.
Note: Every Transmitter within the same local network must be assigned a different broadcast channel in order to
avoid conflicts.
•
IP Setup
This section allows for configuration of the IP acquisition mode and Ethernet settings of the unit. It also provides an
easy way to find the physical unit when installed with many other similar units.
IP Mode & Settings: The IP mode may be switched between "Auto IP", "DHCP" or "Static IP". When the unit
-
is set to Auto IP mode it will automatically assign itself an APIPA address from the 169.254.xxx.xxx range. When the
unit is set to DHCP mode it will attempt to automatically obtain an IP address from a DHCP server. When the IP
mode is set to static IP, you can manually set the IP address, netmask and gateway address. Click the "Apply" button
to save changes made to the IP Mode or Configuration.
Note: The default network setting for this unit is "Auto IP".
Find Your Device: Selecting "Show Me" will cause the unit to immediately begin flashing the LEDs on the
-
front of the unit to make it easy to find. Selecting "Hide Me" returns the LEDs to their normal behaviour. This setting
is useful when troubleshooting an installation with a large number of units in a rack.
•
Casting Mode
10
English
Advertisement
Table of Contents
