Advertisement
User Manual
English
IR Cable Pin Out
Web-Gui Control
Please follow the steps below to control the matrix via Web-Gui.
The default IP address is 192.168.1.100. The matrix's IP address can also be found using RS-232 control.
Send the ASCII command "r ipconfig!" using a serial command tool. The following feedback will then be
shown. The IP address will vary, the below is an example only.
Connect a PC to the LAN port of the matrix using a UTP Cat.6 or above cable. Set the IP address to be in
the same network segment as the matrix.
Input the current IP address of the matrix in the browser of the PC. This will open the Web-Gui page.
Once into the Web-Gui, a login page will be shown.
Select the username from the list and enter the password. The default username and passwords are as
follows:
Username: User, Password: user
Username: Admin, Password: admin
Once entered, please select Login and the Status page will open.
Advertisement
