Lindy 38266 User Manual page 21

Manual English
- Find Your Device: Selecting "Show Me" will cause the unit to immediately begin flashing the LEDs on the front of
the unit to make it easy to find. Selecting "Hide Me" returns the LEDs to their normal behaviour. This setting is useful
when troubleshooting an installation with a large number of units in a rack.
•
Casting Mode
Allows for the selection of the network broadcast mode supported by the Receiver. Click the "Apply" button to save
changes made to the broadcast mode.
Note: Receivers must be set to the same mode as the Transmitter in order to receive video.
- Multicast: This mode sends a single video stream that can be viewed simultaneously by multiple receivers without
increasing bandwidth usage. This mode is ideal for video wall or matrixing scenarios. Multicast mode requires a
network switch with IGMP snooping enabled.
Note: The 3 port network switch built into the Receiver units supports IGMP snooping and may be used to distribute
a multicast stream.
- Unicast: This mode uses a discrete video stream for every connected Receiver and is ideal for simple, point-to-
point, streaming setups. This mode uses considerably more bandwidth than Unicast mode when multiple Receivers
are being used, however it does not require a network switch that supports IGMP snooping.
Functions Tab
The Functions tab provides control over the Receiver's output resolution, video loss settings, as well as a wide variety
of optional features and functions, including USB and Serial control extension. Changes made to these settings
typically require a reboot of the unit. After clicking on "Apply" please follow the reboot instructions in the WebGUI, if
necessary.
18