Lindy 38266 User Manual page 20

Manual
•
Show OSD
Enables or disables the OSD display of the current channel selection.
Note: When setting up a new video wall, or changing the configuration of an existing one, remember to update the
configuration of each Receiver in the system.
Network Tab
The Network tab provides controls over the Receiver's broadcast reception channel, IP configuration, and network
broadcast mode. Changes made to the network settings will require a reboot of the unit. After clicking on "Apply"
please follow the reboot instructions in the WebGUI.
Note: If the IP address is changed then the IP address required for WebGUI access will also change accordingly. If
the new address is assigned via "Auto IP" or "DHCP" it might be necessary to temporarily disable the Video Link
between the Receiver and Transmitter in order to display the units' new IP addresses on the Receiver's HDMI output.
Press and hold the LINK button for 3 seconds to enable or disable the Video Link.
•
Channel Setup
Use the dropdown to select the broadcast reception channel for the Receiver. The Receiver will display the video
stream from the Transmitter using the selected broadcast channel. The available channel range is from 0 to 255.
•
IP Setup
This section allows for configuration of the IP acquisition mode and Ethernet settings of the unit. It also provides an
easy way to find the physical unit when installed with many other similar units.
- IP Mode & Settings: The IP mode may be switched between "Auto IP", "DHCP" or "Static IP". When the unit is set
to Auto IP mode it will automatically assign itself an APIPA address from the 169.254.xxx.xxx range. When the unit
is set to DHCP mode it will attempt to automatically obtain an IP address from a DHCP server. When the IP mode is
set to static IP, you can manually set the IP address, netmask and gateway address. Click the "Apply" button to save
changes made to the IP Mode or Configuration.
Note: The default network setting for this unit is "Auto IP".
17
English