No. 38267 - Receiver Unit - Lindy 38266 User Manual

Manual
4. VGA IN port – Connect an analog video signal source using a standard VGA cable (not included).
5. HDMI IN port - Connect a digital video signal source using a High Speed HDMI cable (not included).
6. LINE IN port – Connect an analog audio source to be delivered on the LINE OUT on the receiver side. Please
note this audio signal will replace the embedded audio stream of the HDMI signal.
7. LINE OUT port – Connect an active speaker set or an audio amplifier to reproduce the signal coming from the
MIC IN audio port on the receiver side.
No. 38267 – Receiver Unit - Front Panel
1. Power LED – Flashes during power up and stays illuminated whilst the unit is operating.
2. Link LED – Stays dark when there is no network connection present. Flashes whilst connecting to a transmitter
unit and stays illuminated once the connection is established.
3. USB 2.0 ports – Used to connect high speed devices like USB flash drives.
4. USB 1.1 ports – Used to connect HID devices like mouse and keyboard.
5. RESET – Push this button using a clip to reboot the unit (settings won't be lost).
6. SWITCH / MODE – Press this button to switch between VGA and HDMI sources. Press and hold this button for
3 seconds to switch between Graphic and Video modes. Graphic mode is designed to improve the detail in static
images (such as a PC Desktop) whilst Video mode is for use with full motion video applications.
7. CH+ / LINK – Press this button to switch to the next stream channel on the network (if available). Press and hold
this button for 3 seconds to disable or enable the video link. Keep pressed during the powering up phase until
the Power and Link LEDs start blinking to reset the unit to factory defaults.
8. CH - / USB – Press this button to switch to the previous stream channel on the network (if available). If the unit
is integrated in a multicast installation press and hold the button for 3 seconds disable or enable the USB link
with the transmitter.
9. IR Eye – Receives the IR signal directly from a standard IR remote control and delivers it to the device connected
to the transmitter unit.
10. IR IN – IR Receiver connection port.
11. IR OUT – IR Emitter connection port.
12. ISP SEL – Must stay switched to the left to enable the RS-232 port. The right position function is reserved for
future use.
RS232 port – Connect a serial device to be controlled from the transmitter side of the installation.
13.
Rear Panel
3
English