Lindy 38266 User Manual page 12

Manual
•
Wall Size and Position Layout
This section of the Video Wall tab is used to define the number of displays used in the video wall as well as the
location of the specific display within the video wall. A typical video wall consists of an equal number of horizontal
and vertical monitors (for example: 2×2 or 3×3), however it is possible to create video walls using this system with a
wider variety of dimensions as long as the end result is still a rectangle (for example: 5×1 or 2×3). Both horizontal
and vertical dimensions are limited to a maximum of 8 displays.
- Vertical Monitor Count: Define the number of displays in the video wall, measured vertically. (Maximum is 8 displays)
- Horizontal Monitor Count: Define the number of displays in the video wall, measured horizontally. (Maximum is 8
displays)
- Row Position: Set the vertical location of the currently controlled display. (Counts top to bottom, from 0 to 7)
- Column Position: Set the horizontal location of the currently controlled display. (Counts left to right, from 0 to 7)
•
Preferences
This section of the Video Wall tab provides additional controls over how the source video is displayed on the video
wall as well as providing a drop down to determine which Receiver to apply changed settings to.
- Stretch Type: Set the video stretch method.
- Selecting "Fit In" will expand the video to exactly fit the dimensions of the video wall regardless of the source's
original aspect ratio.
- Selecting "Stretch Out" will zoom the video until the video wall is filled in all 4 dimensions while maintaining the
aspect ratio of the original source.
- Clockwise Rotate: Set the rotation of the video output in 90 degree increments.
- Apply To: Select which unit(s) to send updated settings to when "Apply" is pressed.
- Selecting "All" will direct updates to the video wall settings of all units in the current video wall group (Transmitter
and Receivers).
-Selecting "This" will direct updates to the video wall settings of the unit whose WebGUI you are currently connected
to.
- Selecting an IP address from the "Hosts" list will direct updates to the video wall settings of the Transmitter with that
IP address.
- Selecting an IP address from the "Clients" list will direct updates to the video wall settings of the Receiver with that
IP address.
- Show OSD: Enables or disables the OSD display of the current channel selection.
Note: When setting up a new video wall, or changing the configuration of an existing one, remember to update the
configuration of each Receiver in the system.
Network Tab
The Network tab provides controls over the Transmitter's broadcast channel, IP configuration, and network broadcast
mode. Changes made to the network settings will require a reboot of the unit. After clicking on "Apply" please follow
the reboot instructions in the WebGUI.
9
English