Siemens SIPROTEC 4 Manual page 32

Configuration in DIGSI 4
2.3 Customization of the Allocations
[sc_Error-Message, 1, en_US]
Figure 2-16
Destination System Interface
The value of the SIPROTEC 4 information is transmitted to the Modbus TCP master. This is possible for the
following information types (column Type in the DIGSI 4 Configuration Matrix):
SP
DP
Out
IntSP
IntDP
MV
MVMV
PMV
Add or remove an information to the Destination column of the system interface by setting/removing the
²
X via context menu in the associated column of the DIGSI 4 Configuration Matrix (see above).
Adding an Allocation
To add an allocation, you must select the position of the information in the Mdbus TCP message and define
the scaling values for measured values (see Chapter Scaling of measured values).
After adding the allocation, the dialog Object properties opens automatically.
Define the message position of the information in the tabs Protocol info Source B, Protocol info Destina-
²
tion F, and Measured value Destination B.
32
Error Message
Single-point indication
Double-point indication
Output annunciation
Internal single-point indication (tagging)
Internal double-point indication (tagging)
Measured value
Power meter (metered measurand, source is a measured value)
Pulse (metered measurand, source is a pulsed binary input)
SIPROTEC 4, Modbus TCP Profile, Manual
C53000-L1840-C582-1, Edition 07.2015