Siemens SIPROTEC 4 Manual page 28

Configuration in DIGSI 4
2.2 Setting the Interfaces
[sc_MappingFileSelection-BusSpecificParameters, 1, en_US]
Figure 2-12
If no mapping-file is currently assigned to the SIPROTEC 4 device then the following entries are available in
the list box Mapping file:
Table 2-1
Selection
<none>
Modbus Slave standard mapping 3-1 to
Modbus Slave standard mapping 3-n
The following entries can be selected in case of an existing mapping-file assignment.
Table 2-2
Selection
<none>
28
Mapping-File Selection and Module-specific Settings
Selection without Module-Specific Settings
Selection with Module-Specific Settings
Description
No mapping-file is assigned to the device.
Selection of a mapping-file 3-1 to 3-n
(n = device-type dependent number of standard mappings).
Description
No mapping-file is assigned to the device.
SIPROTEC 4, Modbus TCP Profile, Manual
C53000-L1840-C582-1, Edition 07.2015