Attaching A Uhf Portable Tuner (For A Uhf Wireless Microphone System) - Sony Digital betacam DVW-970 Operation Manual

Screws removed
in step 1
CAC-12
3
Open the CAC-12 and remove the microphone
adaptor.
Open the CAC-12.
Loosen the screw.
1) Attach the microphone adaptor when using a small-
diameter external microphone.
4
Place an ECM-672 electret condenser microphone in
the CAC-12.
Close the CAC-12.
Tighten the screw.
f
5
Connect the microphone cable to the AUDIO IN CH1
or AUDIO IN CH2 connector.
Set the LINE/MIC/+48 V ON switch to +48 V ON if
you use an external power supply type microphone.
Otherwise, set the switch to MIC.
Note
When you detach the CAC-12 Microphone Holder once
you have attached to the camcorder, be careful not to lose
the two screws fixing the CAC-12. After detaching the
CAC-12, be sure to put the two screws back into their
original places (see the figure illustrating the step 1
operation).
7-5-3 Attaching a UHF Portable
Tuner (for a UHF Wireless
Microphone System)
To use a Sony UHF wireless microphone system, fit one of
the following UHF portable tuners.
• WRR-855A/855B UHF Synthesized Tuner Unit
• WRR-860/862 UHF Portable Tuner.
For each of these UHF portable tuners, use the following
Microphone
1)
attachment procedure.
adaptor
For details, refer to the UHF portable turner manual.
Fitting the WRR-855A/855B
You can use the WRR-855A/855B UHF Synthesized
Tuner Unit simply by inserting it into the slot in the
camcorder, and fastening the fixing screws.
1
ECM-672 or similar
microphone
2
Undo the four fixing screws holding the cover of the
slot, and remove the cover.
Insert the WRR-855A/855B, and fasten the four fixing
screws.
117
Audio Input System