Sony Digital betacam DVW-970 Operation Manual page 25

B (ATW): When this switch is set to B and on the
FUNCTION 2 page of the OPERATION menu,
"WHITE B CH" is set to "ATW", ATW is activated.
When this switch is adjusted, the new setting appears on
the setting change/adjustment progress message display
area of the viewfinder screen for about 3 seconds.
You can assign the ATW ON/OFF function to the ASSIGN
1 switch (push button) on the FUNCTION 1 page of the
USER menu.
For details, see "5-3-5 Assigning Functions to Assignable
Switches" on page 90.
v VIDEO OUT connector
v VIDEO OUT connector (BNC type)
This connector outputs a composite video signal (standard
level, 75-ohm terminated) for a video monitor. With a
video monitor connected to this connector, you can
monitor the picture being shot by the camera or the picture
played back by the VTR. To choose between the composite
video signal output and SDI signal output, use the menu.
When synchronizing the time code of an external VTR
with that of the camcorder, connect this connector to the
GENLOCK IN connector of the external VTR.
By installing the CBK-SD01 extension board (not
supplied), you can output an SDI signal (supporting
embedded audio and the EDH function) from this
connector.
For details on how to select the output signal, see "5-3-2
Selecting the Output Signals" on page 88.
w TEST OUT connector (BNC type)
This connector outputs the video signal (standard level, 75-
ohm terminated) for a video monitor. The output signal can
be selected from composite or RGB. The factory setting is
u TURBO GAIN button
When shooting under extremely poor lighting conditions,
press the button once to boost the video gain to the value
preset on the GAIN SW page of the USER menu (up to 48
dB). To stop boosting the gain, press the button once more.
w TEST OUT connector
x REMOTE connector
Shooting and recording/playback functions (3)
composite, and the setting returns to composite whenever
the unit is powered on.
Depending on menu settings, menus, time code, and shot
data can be superimposed on the image on the monitor.
For details on how to select the test output signal, refer to
the Maintenance Manual.
x REMOTE connector (8-pin)
Connect the RM-B150/B750 Remote Control Unit, which
makes it possible to control the VTR and camera remotely.
Shooting and Recording/Playback Functions
25