Sony Digital betacam DVW-970 Operation Manual page 95

24P (pull-down) mode (DVW-970 with CBK-FC01 only)
23.98 frames per second
A ( O + E )
CCD output
Video output signal
O: Odd
E: Even
After reading from the CCDs in 24P mode (23.98 frames
per second), a pull-down conversion is carried out to the 30
frames (29.97 frames per second) of the normal
progressive scan mode.
Setting the CCD scan mode to the progressive scan mode
The scan mode of the camcorder has been set to the
interlace scan mode at the factory. The FORMAT page of
the OPERATION menu allows you to change the CCD
scan mode to the progressive scan mode or 24P mode
(DVW-970 with CBK-FC01 only).
1
Follow the procedures given in steps 1 to 3 described
in "5-3-4 Specifying an Offset for the Auto White
Balance Setting" on page 89, to display the FORMAT
page of the OPERATION menu.
2
Turn the MENU knob to move the
MODE," and press the MENU knob.
b
The mark on the left of "SCAN MODE" changes to
a z mark, and the z mark on the left of the setting
changes to a ? mark.
19 FORMAT
16:9/4:3 SELECT :
SCAN MODE
UC/J SELECT
("UC/J SELECT" is displayed only for the DVW-970.)
3
Turn the MENU knob to display "PsF" or "24P," and
press the MENU knob.
The z mark changes to a
changes to a z mark.
B ( O + E )
A O A E B O B E
29.97 frames per second
24P mode timing chart
b
mark to "SCAN
16:9
:? I
: UC
b
mark, and the ? mark
C ( O + E ) D ( O + E )
B O C E C O D E
19 FORMAT
16:9/4:3 SELECT :
SCAN MODE
UC/J SELECT
4
To end the menu operation, set the MENU ON/OFF
switch to OFF.
A ( O + E )
D O D E A O A E
16:9
: PsF
: UC
Adjustments and Settings from Menus
95