Installing And Routing Internal Optical Fibers; Connections Between Internal Optical Fibers - Huawei OptiX OSN 3500 Quick Installation Manual

Route the fiber patch cords downwards along the fiber path on the right side of the cabinet and then into the subrack
through the corresponding cable trough. Route the fiber patch cords upwards through the cable trough below the
optical interface board. Insert the fiber connectors into the corresponding optical ports on the board.
NOTE
•
Route the optical fibers in the fiber cable trough of the column in the cabinet. If the two fiber holes do not
provide sufficient space for the optical fibers, you can route the optical fibers through the cable holes.
•
Bind the optical fibers using binding straps, and then bind the optical fibers onto the fixing plate using cable
ties properly so that the optical fibers can be removed freely. When routing the optical fibers, take proper
measures to avoid damage to the optical fiber connectors.
When routing and installing fibers onsite, you need to clean fiber end faces. For detailed operations, see the multimedia
at the following website:
http://support.huawei.com/carrier/docview!docview?nid=DOC1000132657
2

Installing and Routing Internal Optical Fibers

a

Connections Between Internal Optical Fibers

• Fiber connections between the SL16, the BPA, and
the DCU
BPA
SL 16
OUT BOUT
BIN
IN
POUT
PIN
OUT 1
IN 1
OUT 2
IN 2
DCU
OptiX OSN equipment A
DCU
OUT 1
IN 1
OUT 2
IN 2
BPA
SL 16
POUT
IN
PIN
OUT
BOUT
BIN
OptiX OSN equipment
B
64
• Fiber connections between the SL16 and
the BA2
SL 16
IN
OUT
BA 2
OUT 1
IN 1
OUT 2
IN 2
equipment A
OptiX OSN
BA 2 SL 16
OUT 1
OUT
IN 1
IN
OUT 2
IN 2
OptiX OSN equipment B