Huawei OptiX OSN 3500 Quick Installation Manual page 55

3
3 Route the E3/T3/E4/STM-1 cables for the lower
subrack upwards along the side of the cabinet to the
cable distribution plate above the lower subrack.
NOTE
The description uses cable routing on the right side as an example. When routing cables on the left side,
use the same method.
7
Installing and Routing Ethernet Cables
a
Overhead Cabling
• Routing Ethernet cables for the upper subrack
1
1
Route the Ethernet cables into the cabinet through the
cable holes on the top of the cabinet. Then, route the
cables for the upper subrack downwards along the rear
panel of the cabinet to the cable distribution plate
above the upper subrack.
4
4 Connect the cables to the SMB ports on the interface
board from the upper part to the lower part.
2
2
Route the cables through the cable distribution plate, and
then connect them to the RJ45 ports on the Ethernet
board from the upper part to the lower part.
52