Advertisement
42
Now place dashboard (45) and glue.
Then place the flybridge on the top of the roof,
check alignment and fix with superglue.
To match the curve of part 42 to the curve of
the roof, you can place sand paper flat onto the
roof and sand the wall to have a better fit, if
necessary.
Now place the false edge (46) and glue to the
roof.
46
Stand November 2007
42
After the glue has set, you can fit and glue the
front walls (43 + 44). The front panels for the
side (44) have enough oversize for an easy fit.
Now prepare the false edges 47 und 48 from
rest pieces of plywood 3 mm and glue them in
place.
Now the body shell of the superstructure is
ready.
6. Alignment to Deck
At this stage the superstructure will be placed
on the deck and the curve of the lower edge
has to be aligned with the curve of the deck.
This has to be done mainly in the front area.
For this you can mark the deck line to the su-
perstructure with a pencil, layed flat onto the
deck. Then sand the curve.
7. Painting
Now the superstructure can be sprayed with
filler and sanded several times and afterwards
Seite 9
43
rest material 3 mm
47
48
©
Krick Modelltechnik Knittlingen
Advertisement
