Advertisement
21
20 20
19
21
All parts for the inside of the hull should be
ready now. Please varnish them 2 to 3 times
and sand between, that they are water resis-
tant. Also the deck should be varnished from
the underside now.
Place the Servo temporarily into the tray and
drill the holes with 1.5 mm drill fort he Servo
screws.
Drill
Stand November 2007
6. Preparation of the Motor
Solder on the motor the suppression capaci-
tors 103 (10nf) to the connections and to the
motor housing as shown. At this place the
motor housing should be well sanded to have
good connection for the solder. Then solder
the third capacitor 473 (47 nf) between the two
motor connections. Place insulation tube on
the ends before soldering.
Now solder motor wires to the connections.
Servo
After that you can assemble the motor to the
motor frame.
Seite 4
©
Krick Modelltechnik Knittlingen
Advertisement
