Advertisement
14. Assembly of the steering wheel
For this assembly fo the steering wheel you will
need the small laser sheet, 12 cm of brass wire
1 mm, and white glue or Aliphatic glue, a mod-
elling knife, a wire cutter and some sand pa-
per.
Use the cut out on the laser sheet to cut equal
lengths for 6 spokes fom the brass wire 1 mm.
Now cut ut the l5 laser parts from the sheet as
shown.
Stand November 2007
Apply some glue to the outer ring and into the
center of the wheel and plase the spokes care-
fully that they are lying up to the center hole,
but leave it free.
Now place the second outer ring, that the
grooves are placed on the spokes.
Apply some glue to the upper center piece and
place it as well onto the first one.
Now press the complete steering wheel with
some weight until the glue has set.
Carefully cut out the laser cut dummy spokes
from the lower laser part. Then sand the
wooden parts carefully.
Cut a 10 mm brass piece as a shaft and fix it
with glue in the center hole of the steering
wheel. Also place the 2 distance rings with
wood glue.
Now you can stain and varnish the steering
wheel and fix it at the helmstand.
Seite 15
©
Krick Modelltechnik Knittlingen
Advertisement
