Advertisement
Place hand rail (70) without glue and check the
height of the rail support.
70
Make the lower rail from two split pins (71) and
the tube (70).
71
Make the end piece at the left ladder rod from
a piece of brass tube 2 x 7 mm (104) and glue.
Stand November 2007
69
30 mm
70
Seite 12
104
5. Safety Bar
Bend from brass wire 1,5 x 170 mm the safety
bar (72) for the flybridge.
First bend the angles as shown on the top view
on the plan and at the end bend the outer ends
downwords as shown in the side view.
6. Hand Rail
Prepare the hand rail from brass wire 1,5 x 195
mm and 6 split pins (71). Mark the holes at the
sides of the superstructure and drill with 1,5
mm. Slide the split pins onto the wire and fix
the ends into the holes. To achieve an equal
distance to the wall, slide some rest pieces of
wood 3 mm between wall and rail.
65
71
©
Krick Modelltechnik Knittlingen
72
Advertisement
