Advertisement
you can use a lacquer for the finish in the
wished colour.
III. Details
In the following steps the accessories will be
made.
Door, radarbridge, seats, anchor winch, bow
reel, stairs, ladder, radar, throttle lever
1. Door
Sand and varnish the door (62) and glue it to
the painted back wall. Then bend the door
handle from brass wire 1,5x15 mm (108) and
slide a brass tube 2x1,5x7 mm (104) over it for
a thicker handle.
62
2. Radar Bridge
Take part 58 from the laser sheet.
Glue two brass tubes (63) 2x1,5x100 mm on to
the board just at the outer edges. Bend from
brass wire 1,5 mm four supports (66). Fit the
angle according to the angle of the side walls
of the flybridge.
66
63
58
63
66
Stand November 2007
108
66
66
Seite 10
63
58
66
drill
3. Seats
Make the seats from parts 53, 54, 55, 56 and
57.
53
56
55
54
57
53a
©
Krick Modelltechnik Knittlingen
63
54
55
56
Advertisement
