Advertisement
6
5
Now the coaming strips (10 to 14) have to be
glued vertical onto the strips, that they are
flash on the underside and protruding on the
upper side. The superstructer will stand over
this and so no water can come into the model
hull.
5
4. Rudder Tube
Glue the rudder tube (14)to the 2 supports
(15). Use medium or thick super glue or UHU
plus acrylit glue for this. Place the parts onto a
flat surface. When the glue is dry, place the
assembly into the hull, together with the third
support. Glue this support to the rudder tube,
but do not yet glue all into the hull.
15
Stand November 2007
10 bis 13
5
14
Seite 3
5. Motor Mount
Make the motor mount / Servo tray assembly
from parts 16,17 and 18 and glue. You will find
on the laser sheets two different motor mounts.
First compare with the motor, which motor
mount ist he correct one for your motor.
18
16
17
Now make the battery and receiver tray with
parts 19, 20 and 21.
©
Krick Modelltechnik Knittlingen
Advertisement
