Showing The Remaining Battery Time Battery Info; Connecting To A Wall Socket - Sony Handycam DCR-DVD100E Operating Instructions Manual

Step 1 Preparing the power source
Showing the remaining battery time – BATTERY INFO
1
Open the LCD screen while pressing OPEN.
2
Press DISPLAY/BATT INFO.
The remaining battery time appears for a while on the LCD display.
Notes
•The remaining battery time may not be indicated in the following cases:
– The battery pack is not installed correctly.
– The battery pack is damaged.
– The battery pack is empty.
•The number displayed as Battery Info is the approximate recording time.
•While the remaining battery time is being calculated, "CALCULATING BATTERY
INFO..." is displayed.
•It may take some time to display the remaining battery time after DISPLAY/BATT
INFO is pressed.

Connecting to a wall socket

When you use your camcorder for a long time, it is recommended that you power it
from a wall socket using the AC adaptor.
1
Open the DC IN jack cover, then connect the AC adaptor supplied with your
camcorder to the DC IN jack on your camcorder with the plug's v mark facing
up.
2
Connect the mains lead to the AC adaptor.
3
Connect the mains lead to a wall socket.
See page 16 for details.
WARNING
Your camcorder is not disconnected from the AC power source (mains) as long as it is
connected to the wall socket, even if your camcorder itself has been turned off.
Notes
•The AC adaptor can supply power even if the battery pack is attached to your
camcorder.
•The DC IN jack has "source priority". This means that the battery pack cannot supply
any power if the AC adaptor is connected to the DC IN jack, even when the mains
lead is not plugged into a wall socket.
18
-GB
BATTERY INFO
BATTERY CHARGE LEVEL
0% 50% 100%
REC TIME AVAILABLE
LCD SCREEN : 52 min
VIEWFINDER : 60 min
During charging
BATTERY INFO
BATTERY CHARGE LEVEL
0% 50% 100%
REC TIME AVAILABLE
LCD SCREEN : 65 min
VIEWFINDER : 75 min
Fully charged