Setting Up Ip2015/Ip2115 With Multiple Ip15 Handsets Or Ip70H Wireless Headsets; Managing Additional Ip15 Handsets - Alcatel Temporis IP150 Administration And Provisioning Manual

Setting up IP2015/IP2115 with multiple IP15 handsets or IP70H
wireless headsets
Alcatel IP2015/IP2115 IP DECT systems support up to six wireless devices (IP15
handsets or IP70H headsets), six independent sip accounts, and a maximum of four
concurrent calls in wide band.
The basic package consists of one base and one IP15 handset. For this you will only need to
set up the minimum configuration, i.e. IP connectivity and one sip account, to have your
system up and running.
If you wish to use more than one handset and/or more than one account, you will need to
perform some additional configuration steps, either using the WUI or configuration files.
Basically you will be adding the new accounts, managing the new handsets or headsets,
and assigning them to accounts.
To configure additional sip accounts using the web interface, see SIP Account Management
on page 90.
If you prefer to use configuration files, see "sip_account" Module: SIP Account Settings on
page 207.
Note IP70H headsets will not allow you to dial out, so whenever in next paragraphs any
action involving dialing is mentioned it will not be applicable to them.

Managing additional IP15 handsets

To associate a new handset to the base:
If you are installing the basic IP2015/IP2115 package, your handset is already subscribed
to the base. So if you are installing a system with only one handset you can skip this
section.
If you acquire additional handsets you will need to follow these simple steps to associate
them to your base.
1. Press Registration button on the base for 4 seconds, then
release. The two leds will blink in orange
2. In your new IP15 handset, go to Menu>User
Settings>Registration>Handset
3. Select "BASE" softkey and press # key. Input system PIN
is you are asked for it. Default is 0000
4. Your handset should be subscribed and display idle screen
with the assigned handset number (1 to 6)
To associate a headset to the base:
1. Press Registration button on the base for 4 seconds, then release. The two leds will blink
in orange
2. Remove and replace your unregistered IP70H on its charging cradle (connected to the
power supply). It must be flashing rapidly in red and blue
Business IP Range Administration and Provisioning Guide ed 2.2 53/247