Assigning Sip Accounts To Ip15 Handsets Or Ip70H Headsets - Alcatel Temporis IP150 Administration And Provisioning Manual

3. After a few seconds your headset should be subscribed and show only the red or blue
lights, depending on battery charge status
Note: If the cordless headset is registered to another phone, it must be deregistered first.
See "Deregistering a DECT headset".
To rename a handset/headset:
Handset name can be modified to suit your needs. This name will be shown on the handset
idle screen, but also on the web UI or menus where you need to select a wireless device (to
intercom, transfer, etc). Handset menu, IP2015/IP2115 web interface or configuration files
can be used for this purpose. Note the handset has to be associated with the base. For
IP70H headset only web UI or configuration files can be used.
To change the name displayed on the idle screen from handset menu:
1. On the target IP15 handset, go to Menu>User Settings>Phone rename
2. Edit the name and press Set
To change handset/headset name using WUI, see Handset name on page 139
To configure handset/headset name using provisioning files, see "hs_settings" Module:
Handset management Settings on page 240
To disassociate a handset/headset from the base:
1. On one subscribed IP15 handset, go to Menu>User
Settings>Registration>Handset>Deregistration
2. Enter system PIN. Default is 0000
3. Select the handset or headset you wish to unregister. If only one handset were
registered, then it will be automatically unregistered without selecting anything
4. The handset will display the unregistered status screen. The headset will flash slowly in
red and blue
To disassociate all handsets/headsets from the base:
1. Press and hold Paging/Registration key for 10secs
2. Release the key and then short press again
3. All devices will be unregistered from the base

Assigning sip accounts to IP15 handsets or IP70H headsets

By default all handsets/headsets can use all active accounts, and all of them will use sip
account 1 to dial out.
You can modify this behavior by deciding which devices are allowed to use which accounts,
and what the default dial out account for each of them will be. WUI and config files can be
used for this purpose.
To assign handsets to accounts and default dial out account using the web interface, see
Handset Settings, Account assignment on page 138
To assign handsets to accounts and default dial out account using configuration file
parameters, see "hs_settings" Module: Handset management Settings on page 240
Moreover, you can select dialing line among assigned accounts on a per call basis. To do
this, simply press LINE softkey on your IP15 handset and make your choice.
Business IP Range Administration and Provisioning Guide ed 2.2 54/247