Alcatel Temporis IP150 Administration And Provisioning Manual page 32

IMPORTANT INFORMATION
1. Use only original power adapters. Contact your distributor to order.
2. The power adapter is intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
If there is a networked computer and no extra Ethernet wall ports near the phone, then the
phone and PC can share the same network connection.
To share a network connection with a PC:
3. Plug a Cat.-5 Ethernet cable into the PC port on the phone.
4. Plug the other end of the Cat.-5 Ethernet cable into your computer's network port.
For IP300, if a GigE network is being used, a computer connected through the phone will be
limited to 100 Mbits/s. If you require a GigE Ethernet rate, use separate Ethernet
connections for the phone and the computer. This remark is not applicable to IP251G,
IP301G or IP701G, since all of them have a GigE switch.
If a PC is connected to your network through a phone, any phone resets and power or
network interruptions will disrupt the PC's connection to the network.
To mount the phone on the wall:
1. Put the corded handset aside. Use a coin to rotate the handset tab 180 degrees. The
protruding edge holds the corded handset when the phone is mounted on the wall.
2. Connect the network cable(s) and power adapter (if required).
3. Hang the phone on the wall using wall mount holes.
Business IP Range Administration and Provisioning Guide ed 2.2 32/247