Configuration - Encoder 1 - Siemens SINAMICS S120 System Manual

Commissioning

4.11 Configuration - encoder 1 ... 3

4.11 Configuration - encoder 1 ... 3
The name of the encoder and the Sensor Module are displayed here via which the encoder
is connected. Encoder selection:
Figure 4-11
● Case 1: Automatically selected with EnDat and DRIVE-CLiQ, no further settings required.
To check the default settings, press the "Enter data" softkey.
● Case 2: Encoder was not automatically detected. If the connected encoder is in the list,
select the encoder based on the name/code number. Otherwise, select a similar encoder
from the list and press the "Enter data" softkey to enter the encoder data.
Further actions:
● With the "Identify" softkey restart the identification of the encoder in order to check
whether the displayed encoder matches the encoder that is actually connected. The
encoder can only be identified if it is an absolute encoder or a DRIVE-CLiQ encoder.
66
Configuration - encoder 1 ... 3
System Manual, 04/2015, 6SL3097-4BA00-0BP1
Hydraulic Drive