Table of Contents
Advertisement
Power Supply Wiring
NOTES:
Figure 7 shows how to wire the connector.
DTP T DSW 4K
Figure 7.
CAUTION: The wires must be kept separate while the power supply is plugged in.
ATTENTION : Les deux cordons d'alimentation doivent être tenus à l'écart l'un de
•
In point-to-point applications, only one power supply is required; a single power
supply connected to the switcher can power both the switcher and a compatible
receiver.
•
The DTP T DSW 4K series can only transmit remote power. It cannot receive
remote power from a locally powered receiver.
•
Remote power is only available when the unit is set to DTP mode. When the unit is
set to HDBaseT mode, remote power and analog audio are disabled.
•
A power supply is included with each individually-packaged switcher.
•
Do not tin the power supply leads before installing them in the direct insertion
connector. Tinned wires are not as secure in the connectors and could be pulled
out.
Power Supply
Switcher
POWER
12V
1.4A MAX
AC Power Cord
Power
Receptacle
DC Power Cord
Captive Screw
Connector
Power Supply
Output Cord
Power Connector Wiring
Remove power before wiring.
l'autre quand l'alimentation est branchée. Couper l'alimentation avant de faire
l'installation électrique.
Extron DTP T DSW 4K Series • Installation and Operation
PS 1220
DC Power
Outputs
DO NOT USE
Captive Screw
Connector
Tie
Wrap
9
Advertisement
Table of Contents
