Extron electronics DTP T DSW 4K Series User Manual page 19

= TMDS output format
X1)
= Native resolution and refresh rate
X1!
from selected EDID
= Pixel phase
X1@
= Total pixels
X1#
= Horizontal/Vertical start
X1$
= Verbose mode
X1&
= Tally pin mode on channel mute
X1*
= Embedded audio format
X1(
= DTP/HDBaseT switch position
X2)
= HDCP output mode
X2!
0 = Auto (default)
1 = DVI RGB 444
2 = HDMI RGB "Full"
3 = HDMI RGB "Limited"
4 = HDMI YUV 444 "Full"
5 = HDMI YUV 444 "Limited"
6 = HDMI YUV 422 "Full"
7 = HDMI YUV 422 "Limited"
Example:
1920x1200 @ 60Hz
0 to 63 (32 is default)
±255 of the default value (depends on input rate)
0 to 255 (128 is default)
0 = clear/none
1 = verbose mode (default)
2 = tagged responses for queries
3 = verbose mode and tagged responses for
queries
0 = always on (default)
1 = off when muted
2 = blink when muted
HDMI and DisplayPort:
0 = auto (default)
1 = force existing digital/embedded audio
2 = force embedded analog audio
VGA:
0 = disable embedded DVI format audio
(default)
1 = enable embedded audio (HDMI format)
0 = DTP mode (default)
1 = HDBaseT mode
0 = Encrypt as required by input
(Continuous trials for HDMI sinks, attempt for
10 seconds on DVI sinks,then fail)
1 = Always encrypt
(Continuous trials for HDMI sinks, attempt for
10 seconds on DVI sinks,then fail)
2 = Encrypt as required by input
(Continuous trials for HDMI sinks and DVI sinks)
3 = Always encrypt
(Continuous trials for HDMI sinks and DVI sinks)
Extron DTP T DSW 4K Series • SIS Commands 13