Motor Programming - Screen Innovations Sail Installation Manual

If faults occur, proceed as follows:
1. Check the remote control battery.
- The LEDs must flash.
2. Check that the motor is powered.
3. Clear the motor's memory.
- Ensure the motor is powered.
- Cut power for 2 sec.
- Reconnect power for 10 sec.
- Cut power for 2 sec.
- Reconnect the power.
- The motor runs for 5 sec. then stops.
- Press and hold down the Prog. key (D) at the back of the remote control for about 5 sec.
until the motor performs an UP/DOWN movement.
- The motor's memory is completely blank.
A
B
C
Rev.1 - 03.2018
D
SCREEN INNOVATIONS - INSTALLATION MANUAL - SAIL
5
4. Pre-record the remote control.
- Power the motor.
- Press the "up arrow" (A) and "down arrow" keys (C) simultaneously.
- Check the direction of rotation by pressing the "up arrow" A (the sail closes) and "down
arrow" keys C (the sail opens).
- If the direction (open/close) is incorrect, press MY (B) until the motor performs an UP/
DOWN movement.
5. Memorise the transmitter.
- Press the Prog. key (D) until the sail moves UP/DOWN.
NOTE
- Ensure the motor is powered.
- Cut power for 2 sec.
- Reconnect power for 10 sec.
- Cut power for 2 sec.
- Reconnect the power.
- The motor runs for 5 sec. then stops.
- Press and hold down the Prog. key (D) at the back of the remote control for about 5 sec. until
the motor performs an UP/DOWN movement.
- The remote control acquires the existing programming.
The motor has two limit stops: one yellow and one white.
Yellow button (limit stop for sail completely wound up); white button (limit stop for sail
completely open).
Button "up" (limit stop OFF); button "down" (limit stop ON).
Once the sails are replaced (open position), press button "A" on the remote control and start the
motor to wind them up while keeping both the yellow and the white buttons "up" (OFF).
Wind up to about half way and couple the two spring clips to the sails' eyelets.
Release the button to stop winding.
Resume and complete winding until only the two triangles with the company logo are visible.
Press the yellow button "down" for limit stop ON.
Press the "C" button to start opening the sails.
At the point of maximum tension (sails perfectly horizontal), release the button and press the
white button "down" to switch on the limit stop.
Open/close the sails a couple more times to verify the correct limit stop position and tension the
sails correctly.
24 of 28