Table of Contents
Advertisement
1. Press the Prog. key (D) for about 2 sec. on the remote control already memorised until the
motors perform an UP/DOWN movement, indicating that the motor or the receiver has
entered programming mode.
2. Press the anemometer Prog. key (E) (red key) for about 5 sec. The motors perform a brief UP/
DOWN movement, indicating that the address of the sensor has been memorised. The system
then quits programming mode automatically.
3. Adjust the anemometer based on the value supplied by the manufacturer.
N.B.: Do not tamper with the seal covering the wind intensity regulator (preset by the
manufacturer).
Breakage of or even partial tampering with the seal invalidates the warranty and relieves
the manufacturer of any liability for resulting damages.
25 of 28
6
SCREEN INNOVATIONS - INSTALLATION MANUAL - SAIL
E
Rev.1 - 03.2018
Advertisement
Table of Contents
