Table of Contents
Advertisement
SYMBOLS
SYMBOLS
The symbols indicated are used to draw the attention of the installer to arguments of particular
importance for the safety of persons, the product or to indicate particular operating conditions.
Attention: general operating note
Attention: greater attention to what you are reading
Attention: general hazard; possible risk of damage to persons, property, components
Attention: risk of electrical hazard
Attention: risk of crushing hands
Contact: Screen Innovations or the authorised retailer
GENERAL PRECAUTIONS
Before undertaking any assembly, maintenance or cleaning operations, make sure
that you have fully understood the instructions in this manual.
Failure to respect the regulations contained herein relieves Screen Innovations of
all responsibility for damage caused to persons, animals, property and/or
components.
The installation personnel must scrupulously comply with the local accident
prevention regulations in force.
All electrical connections for movement, installation of automation accessories
etc. must only be made by qualified personnel.
If the structure is motorised and installed at a height of less than 250 cm from the ground, the
control button must be of the 'dead-man' type and the opening and closing operations must be
clearly visible.
2 of 28
In the case of any incompatibility, contact Screen Innovations
GENERAL SAFETY WARNINGS
Sail is designed for a specific use (as outlined in this manual); any use other than that envisaged shall
relieve Screen Innovations of any responsibility.
When using the awning it is good practice to remember that all moving parts can be a source of
danger.
It is compulsory to cut off the power supply (if present) when carrying out an installation,
maintenance, repair or adjustment intervention.
It is recommended that a caution sign be placed on the power supply master switch with
the following indications:
"Attention! Do not touch. Service personnel at work".
PRECAUTIONS AND WARNINGS
The maintenance and installation personnel (installers, electricians etc.) must have sufficient
expertise and psychophysical and attitudinal requirements for undertaking the tasks at hand.
Always check the correct mounting and working efficiency of the electrical and manual drives
during the assembly.
In case of anomalies, immediately stop the work and contact the service
department of Screen Innovations
The use of non-original spare parts, or unauthorised interventions or
modifications shall relieve Screen Innovations of any responsibility for damage
caused to persons, animals or property. It is absolutely forbidden to tamper with
the fixings, the supports, the guides, the fixtures, the command and idler units
and any other component of the Sail.
Rev.1 - 03.2018
Advertisement
Table of Contents
