NEW BRUNSWICK SCIENTIFIC BioFlo 415 Manual To Operations page 52

40
Figure 8: Inputs & Outputs for Ancillary Equipment
For the user's addition of
non-factory-installed REDOX or
a 2nd pH/DO controller
For the
connection of a
2nd DISPLAY
2 USB PORTS
For use with
BioCommand Plus
supervisory
software.
An NBS BioCommand Plus advanced supervisory software program is available
which will enable the operator to interface with a computer that has a Windows
(or higher) operating system. With this software, you will be able to establish or
change the setpoints for temperature, pH, DO, agitation speed and pump flow rate.
You will also be able to read and log the current values of any parameters (temp, pH,
DO, air flow, pump flow rate, levels and agitation) that are monitored. The data can
also be stored, plotted and, afterwards, transferred to other commonly available
programs, to be manipulated and analyzed in various ways.
Table 4, on the following page, identifies the pin designations for this 25-pin
RS232/422 connector:
BioFlo 415 M1360-0050
ANALOG INPUTS & OUTPUTS
are easily accessible
Not in use at this
time
For future expansion
User's Guide
®
2000