NEW BRUNSWICK SCIENTIFIC BioFlo 415 Manual To Operations page 100

88
1. Press here to
open a touchpad.
The name you
write in this box
will appear on a
colored button
tab on the top
menu line.
3. Press the
appropriate option.
Options change
depending on the
number of TMFCs
present. See
Sections 15.1.1–
15.1.4 for details.
Name your unit using the Unit Name edit box touchpad; a corresponding colored
button tab. In this sample screen (Figure 23), the Unit Name, BioFlo 415, is also
written on the menu line button tab. You may prefer to name the unit by its
designation in the
Controller Operating Mode settings (in the sample screen above the controller is set to
"O2 Enrich – Direct or Cascade Driven") depend on the number of thermal mass flow
controllers (TMFCs) in your system. See Sections 15.1.1-15.1.4 for details on gas
control, through the
Finally, you can also use this screen to change your auxiliary pH/DO module selection
by pressing the other option button.
The Save Changes
loops accordingly. Although you can save each change one at a time in this screen by
pressing it, you can also wait until all changes have been selected. If you leave this
screen, however, and wish to save your changes, be sure to press the
button before you move to another screen.
BioFlo 415 M1360-0050
Figure 23: Controller Setup Screen (Fermentation)
Hardware Setup
Controller Setup
button saves your new selections and reconfigures all control
2. New Unit Name button tab appears here.
screen (see Section 15.4), which is Unit1.
screen and the gas process loop gauge screens.
4. Press the
appropriate
option button
if you need
to change
the Auxiliary
pH/DO
module
designation.
Save Changes
User's Guide