NEW BRUNSWICK SCIENTIFIC BioFlo 415 Manual To Operations page 32

20
7. With reference to Figures 7 (above) and 1a, attach the upper connection of
the exhaust condenser to the cabinet's
8. Connect the DO and pH cables to the pH and DO probes, then plug them in
to the side panel on the cabinet (see Figure 1a, repeated on the following
page).
9. Connect the vessel light cable to the
panel (see Figure 1a).
10. Connect the exhaust heater (see Figure 5) to the
on the side of the cabinet.
11. Confirm that the rupture disk (in back of the vessel) and the safety release
valve (in back of the vessel jacket) are connected to tubing or hoses that go
to the drain line.
Figure 1a: Control Cabinet Service Connections
BioFlo 415 M1360-0050
UPPER CONDENSER
on the cabinet
VESSEL LIGHT JACK
EXH. HEATER
User's Guide
connection.
connector