Web-Based Access Control Solution
ACW2-XN
DPS input not working
Key indicators
•
The green LED on the DPS input on the relevant AW2 module is on when the door is closed.
(Picture shows the LED for DPS1 illuminated)
Analysis
•
Has the DPS input been wired correctly?
o
Wire the DPS input correctly.
•
Has the DPS input been configured correctly in the software?
o
Configure the DPS input correctly in the software.
•
Has the DPS sensor been installed such that the magnet and switch are close enough together, to
function correctly?
o
Mount the DPS sensor and magnet close enough together to work.
•
Is the DPS sensor defective?
o
Replace DPs sensor.
•
Is the Wiegand Door Module defective?
o
Replace the Wiegand Door Module.
Page 18 of 27
Technical Service Guide
© 2017 HID Global Corporation. All rights reserved.