Learning New Devices (With Ground Wire); Learning New Devices (Without Ground Wire) - Gemini 953 Installation And Use Manual

12.0 - LEARNING NEW DEVICES
(With BROWN/GREEN WIRE GROUND CONNECTION)
The alarm is supplied with 2 remote controls and 1 electronic key but extra
optional devices can be added.
To learn a new device, proceed as follows:
!
Make sure passive arming feature is disabled
!
Disarm the alarm system via remote control or electronic key.
!
Lift the seat or open the topcase or, if no contact switch is fitted, ground the
BROWN-GREEN wire .
!
Connect the learning button to the relative connector, YELLOW or yellow
sheathed.
!
P ress and hold the learning button .
!
Turn ignition key "ON".
!
Two flashes of the turn indicators and two beeps, a high and a low tone, will
confirm the system is in learn mode.
!
Release the button.
!
P ress one of the buttons on the remote control to be learned or insert the
electronic key in its receptacle .
!
A flash of the turn indicators and a beep will indicate the new device has
been learned .
!
If other devices need to be learned, press and release the learning button
once again and then press the remote control button or insert the electronic
key in its receptacle .
!
Turn ignition key "OFF" to exit the procedure, a low-tone beep and a single
flash of the direction indicators will confirm the end of the procedure
!
Close the seat or topcase or remove the BROWN/GREEN wire from
ground.
CAUTION
Alarm memory will only store 8 devices.
Saving an extra device will automtically delete the first one.
Page 27
The alarm is supplied with 2 remote controls and 1 electronic key but extra
optional devices can be added.
To learn a new device, proceed as follows:
. Make sure passive arming feauture is disabled
.
13.0 - LEARNING NEW DEVICES
(Without BROWN/GREEN WIRE GROUND CONNECTION)
!
Disarm the alarm system via remote control or electronic key.
!
Turn ignition key "ON".
!
The status LED will turn ON for 1".
!
While the LED is ON, press both buttons on the remote control
simultaneously or insert the electronic key into its receptacle.
!
Two flashes of the turn indicators and two beeps, a high and a low tone, will
confirm the system is in learn mode.
!
P ress one of the buttons on the remote control to be learned or insert the
electronic key in its receptacle.
!
If other devices need to be learned
buttons on the remote control or insert the electronic key in its receptacle
!
T urn ignition key "OFF" to exit the procedure.
!
A low-tone beep and a flash of the turn indicators will confirm the end of the
procedure .
CAUTION
Alarm memory will only store 8 devices.
Saving an extra device will automtically delete the first one.
.
, wait 2" and then p ress one of the
.
Page 28