Diode Installation; Learning New Devices; Without Grounding The Brown/Green Wire - Gemini 953NH User's And Installer's Manual

22.0 - DIODE INSTALLATION

How to tell if you need to install a diode:
!
Activate one of the turn indicators, turn ignition key OFF and arm the alarm.
!
If the instrument panel lights up when the turn indicators are activated, a
diode needs to be installed (follow diagram below).
Vehicle wiring harness
Before
WHITE wire
Cut
BLACK wire
Live feed to
turn indicators

23.0 - LEARNING NEW DEVICES

The alarm system is supplied with 1 active remote control and 1 TAG that must
be activated.
To pair the TAG and learn new devices, follow one of the 2 procedures:
CAUTION
Alarm memory will only store 8 devices.
Saving an extra device will automatically delete the first one.
23.1 - BY GROUNDING THE BROWN/GREEN WIRE:
!
Disarm the alarm system via remote control.
!
Lift the seat or open the topcase (if fitted with a contact switch) otherwise
ground the BROWN/GREEN wire.
! Ground the White-Violet wire (with or without a Yellow end connector).
PAGE 25
After
Turn indicator
relay
Diode installed
in-line
Vehicle original
wire
!
Turn ignition key in ON.
!
2 flashes of the turn indicators and 2 confirmation tones (1 Bop and 1 Beep)
will acknowledge the system is in learn mode.
!
Disconnect the White-Violet wire.
!
Press the TAG button or one of the buttons on the remote control to be
learned.
!
A flash of the turn indicators and a Beep will confirm the new remote has
been learned.
!
If other devices need to be learned,
the button on the device to be learned.
!
To exit the learn procedure, turn ignition key OFF. A Bop and a single flash
of the turn indicators will confirm the end of the procedure.
!
Close the seat/topcase or remove the BROWN/GREEN wire from
ground.

23.2 - WITHOUT GROUNDING THE BROWN/GREEN WIRE:

!
Disarm the alarm system via remote control.
!
Turn ignition key in ON.
!
The status LED will light up for 1 sec.; while the LED is ON, simultaneously
press both buttons on the active remote control.
!
2 flashes of the turn indicators and 2 confirmation tones (1Bop and 1 Beep)
will acknowledge the system is in learn mode.
!
Press the TAG button or one of the buttons on the remote control to be
learned .
!
If other devices need to be learned, wait 2 sec. and then press the button on
the device to be learned.
!
To exit the learn procedure, turn ignition key OFF.
!
A Bop and a single flash of the turn indicators will confirm the end of the
procedure.
repeat the above procedure then press
PAGE 26