Pin-Code Customization - Gemini 953 Installation And Use Manual

10.0 - PIN-CODE CUSTOMIZATION

Here below is a step-by-step example showing how to customize the PIN-
CODE. In this case the selected PIN-CODE is
Disarm the alarm
Ground the BROWN/GREEN wire.
BROWN/GREEN
NEGATIVE
Turn ignition key "ON"
The status LED will light up for 0.5 seconds.
While the LED is ON, simultaneously press both buttons on the remote
control.
The alarm will beep twice and the LED will turn ON steady.
0.5
sec.
Remove the BROWN-GREEN wire
from negative.
BROWN-GREEN
NEGATIVE
Page 11
2-3-4-1 .
system .
Open the seat (if protected by a
contact switch).
Boop Steady
ON
Boop
Close the s eat ( protected by a if
contact switch).
P ress both buttons at the same time.
The LED will
Turn ignition key "OFF"
After 4 seconds, the LED will flash 9 times. Count the flashes and turn
ignition key "ON" and "OFF" when the number of flashes equals the new
PIN-CODE 1st digit.
Key "ON"
After 4", the LED will flash again 9 times.
Repeat the above steps to enter the 2nd digit.
Key "ON"
Repeat the above steps to enter the last two digits.
When the 4th digit is entered, the system automatically exits the
procedure. Two low tone acoustic signals and a high tone signal will
confirm the code has been entered successfully.
Last
Key "ON"
digit
turn OFF.
LED
OFF
LED
Key "OFF"
OFF
LED
Key "OFF"
OFF
Boop
Key "OFF"
Boop
Beep
Page 12