User Manual; Electronic Key; Arming; Topcase/Seat Open Warning Signal - Gemini 953 Installation And Use Manual

USER MANUAL

3.0 - ALARM SYSTEM CONTROL DEVICES
The remote controls and electronic key are used to operate the alarm system.
A PIN-CODE can also be used to emergency override the system should the
remote control be lost or inoperative. Override PIN CODE is entered by
means of ignition key (see chapters 8 and 9).
3.1 - REMOTE CONTROL
The remote control has 2 different function buttons each of which
corresponds to a control signal that activates a selected action according to
the operational condition and alarm configuration.
The textured button is for arming/disarming the alarm while the smooth button
is used to exclude or trigger the siren.
The remote control has a low charge battery indicator that gives you early
warning to avoid malfunctioning. When the batteries are fully charged, the
LED will show a steady light at the press of a button. If the batteries are low,
the LED will start blinking when the button is pressed.
!
Button 1: Alarm system arming/disarming
!
Anti-hijack feature activation
!
Hazard lights feature activation
!
Button 2: Anti-hijack feature activation
!
Panic siren activation/deactivation
!
Siren silencing during alarm conditions
!
Siren ON/OFF when arming
!
Motion sensor programming and setting

3.2 - ELECTRONIC KEY

The electronic key is a simplified remote control. In emergency situations (ex.
in case of remote control failure), it can be used to arm/disarm the alarm or
activate/deactivate the anti-hijack feature (if enabled).
To use the electronic key, simply touch it to its receptacle.
The touch receptacle incorporates a LED warning light that serves as both a
system status indicator and a visual theft deterrent.
Page 3
Press remote control button 1 or insert the electronic key into its receptacle to
arm the alarm system. Arming is confirmed by a flash of the turn indicators and
2 short beeps. The LED turns ON steady.
LED
indicator
If, during the arming process, the topcase or seat are open or incorrectly closed, a
Button 1
low-tone signal (boop) will sound after the arming confirmation tones.
The alarm will arm but an alarm condition will be triggered after the pre-arm mode.
Button 2
After the arming confirmation signals, the LED turns ON steady to indicate the system
is in pre-arm mode; it will become fully active after 20".
Engine immobilization and optional module inputs are active during the pre-arm mode.
During the first 4" of the pre-arm mode, the alarm siren can be excluded by
pressing remote control button 2. The turn indicators will give a quick flash to
confirm the siren has been excluded.
Electronic Key Receptacle Positioning
Electronic key
4.0 - SYSTEM OPERATION - BASIC CONFIGURATION

4.1 - ARMING

4.2 -

TOPCASE/SEAT OPEN WARNING SIGNAL

4.3 -

PRE-ARM MODE

4.4 - SIREN EXCLUSION

CAUTION
If the siren is excluded (Mute alarm) only the turn indicators will flash
during an alarm event. Engine immobilization will remain enabled.
NB: Siren exclusion is bound to each single arming cycle.
Electronic key
Page 4