Table of Contents
Advertisement
9.0 - PAIRING NEW DEVICES
9.1 - With BROWN/GREEN wire ground connection
The alarm is supplied with 2 remote controls and 1 override key but other
optional devices can be added.
CAUTION
Alarm memory will only store 8 devices.
Saving an extra device will automatically delete the first one.
To pair a new device, proceed as follows:
!
Make sure passive arming is disabled.
!
Arm and then disarm the alarm via remote control or override key.
!
Lift the seat or open the topcase or, if there is no contact switch, ground the
BROWN-GREEN wire.
!
Connect the WHITE-VIOLET wire to ground.
!
Turn ignition key to ON.
!
Two flashes of the turn indicators, a Beep and a Bop will confirm the system
is in learn mode.
!
Remove the WHITE-VIOLET wire from ground.
!
Depending on which device is to be paired either press one of the remote
control buttons OR touch the override key to its receptacle OR make the
magnetic contact transmit (bring contact and magnet together and then
move apart) OR press the button on the opening detector, make the infrared
sensor
or
wireless hyper-frequency
instructions .
)
!
A flash of the turn indicators and a Beep will
completed successfully.
!
To pair another device, ground the WHITE-VIOLET wire for 1 sec.
!
To exit learn mode, turn ignition key OFF.
!
A Bop and
a flash of the
turn
indicators
!
Close the seat/topcase or remove the BROWN/GREEN wire from ground.
PAGE12
sensor
transmit (refer to sensor
confirm the operation has been
will confirm the end of the procedure.
9.2 - Without BROWN/GREEN wire ground connection
To pair a new device, proceed as follows:
!
Make sure passive arming is disabled.
!
Arm and then disarm the alarm via remote control or override key.
!
T
urn ignition key to ON
!
The status LED will turn ON for 1 sec.;
!
While the LED is ON, simultaneously press both buttons on the remote
control or touch the override key to its receptacle.
!
Two flashes of the turn indicators, a Beep and a Bop will confirm the
system is in learn mode.
!
Depending on which device is to be paired either press one of the remote
control buttons OR touch the override key to its receptacle OR make the
magnetic contact transmit (bring contact and magnet together and then
move apart) OR press the button on the opening detector, make the
infrared sensor
or
wireless hyper-frequency
sensor instructions .
)
!
If another device needs to be paired, wait 2 sec. before doing so.
!
To exit learn mode , turn ignition key OFF.
!
A Bop and
a flash of the
turn
indicators
procedure.
.
sensor
transmit (refer to
will confirm the end of the
PAGE13
Advertisement
Table of Contents
