Alarm Unit Sealing; Accessories Positioning; Receptacle For Electronic Key And Led Indicator - Gemini 953 Installation And Use Manual

3.0 - ALARM UNIT SEALING

To seal the alarm, position the
rubber cap over the external edge
of the alarm housing as shown
below.
Pull the plastic rectangular flange
over the rubber cap and secure
with the supplied screws.
Do not over tighten the screws.
Alarm unit sealed
Page 17

4.0 - ACCESSORIES POSITIONING

4.1 - RECEPTACLE FOR ELECTRONIC KEY AND LED INDICATOR

The receptacle with built-in LED (or the LED) must be installed where it can
readily be seen and accessed by the user. The LED warning light serves as
both a system status indicator and a visual theft deterrent
Always check for rear clearance before drilling. If drilling a hole in the plastic
dash, check the position of the handlebars with the steering lock engaged.
Make sure the LED will not be covered by the handlebars when the vehicle is
parked.
Drill size for the electronic key receptacle: 13mm.
Drill size for the LED indicator: 10mm .
Electronic key
4.2 - CONTACT SWITCH (OPTIONAL)
A contact switch can be fitted to protect the seat or topcase. It must be installed
in such a way as to detect the opening of the seat/topcase without being
accessible from the outside. The trigger threshold must be carefully set to
avoid false alarms.
D o not ground the switch terminal to the vehicle frame as it might not be
connected to the battery negative pole. Connect to a cable that provides
continuous ground such as the indicator lamp negative lead.
NB: If no contact switch is fitted, the GREEN/BROWN wire will remain free for
other possible uses .
Electronic key
Page 18