Replacing Remote Control Batteries; Waste Electrical And Electronic Equipment; (Weee) Directive; Warning - Gemini 953 Installation And Use Manual

11.0 - REPLACING REMOTE CONTROL BATTERIES

The remote control operates using alkaline batteries. When the batteries are
too weak, replace them as follows:
BATTERIES
Remove the
discharged batteries
Separate the
and insert the new
remote halves
ones taking care not to
taking care not to
invert the battery
damage the
polarity.
internal circuit.

WARNING

!
U se only CR1616
Different type batteries can seriously damage the remote control unit.
Discard used batteries properly in special dedicated containers

12.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT

(WEEE) DIRECTIVE

The present device does not fall within the scope of Directive 2002/96/EC on
Waste Electrical and Electronic Equipment (WEEE) as specified in art. 2.1 of
L.D. no. 151 of 25/07/2005.
13.0 - TECHNICAL SPECIFICATIONS
Power supply
Supply voltage range
Current absorption @ 12Vdc
Current absorption in sleep-mode
Siren sound level
Relay capacity
Page 13
Close the
remote halves
and make sure it
works properly.
batteries.
.
12 Vdc
9Vdc-15Vdc
<0,7mA (system armed and
LED flashing )
< 1 µA
118 dBA @1 meter
8A
R&TTE Declaration of Conformity
Doc ref. No. 2010-01
We, the undersigned,
Company GEMINI TECHNOLOGIES S.p.A
Address, City Via Luigi Galvani 12, 21020 Bodio Lomnago (VA)
Country Italy
Phone number +39 0332 943211
Fax number +39 0332 948080
Declare under our sole responsibility that the following eqipment:
Product description / Remote control at 433,92 Mhz for vehicle
Intended use alarm system
EU / EFTA member states EU: all members
intended for use EFTA: all members
Member states with restrictive use None
Manufacturer GEMINI TECHNOLOGIES S.p.A.
Brand name GEMINI
Type / Model 7208E and 7218E
Is tested to and conforms with the essential requirements as mentioned in Art. 3.1 (a) for
protection of Health and Safety of the user and any other person and in Art. 3.1 (b) for
Elecromagnetic Compatibility, as included in the following standards:
Art. of Directive Standard
3.1 (a) Health EN 50371
3.1 (a) Safety EN 60950-1 +A11
3.1 (b) EMC EN 301 489-3
3.1 (b) EMC E 301 489-1 N
And is tested to and conforms to Art. 3.2, with the essential radio test suites so that it
effectively uses the frequency spectrum allocated to terrestrial/space radio
communication and orbital resources so to as avoid harmful interference, as included in
following standards:
Art. of Directive Standard
3.2 Spectrum EN300 220-2
And therefore complies with the essential requirements and provisions of the
199/5/EC of the European Parliament and of the council of March 9, 1999 on Radio
Equipment and Telecommunications Terminal Equipment and the mutual recognition of
theis conformity and with the provisions of Annex II.
TCF reference nr.
Date
Name and position
Date of issue of the standard
2002
2006; 2009
V2.1.1 (2009-05)
V1.8.1 (2008-04)
Date of issue of the standard
V2.3.1 (2010-02)
Directive
TCF_ 7208E/7218E
August 23, 2010
Andrea Rossi, General