Caution - Gemini 953 Installation And Use Manual

INSTALLER MANUAL
CONTENTS
1.0 - PRELIMINARY ADVICE......................................................
2.0 - ALARM UNIT POSITIONING..............................................
3.0 - ALARM UNIT SEALING......................................................
4.0 - ACCESSORIES POSITIONING..........................................
4.1 - Receptacle for electronic key and LED indicator..............
4.2 - Contact switch (optional)...................................................
5.0 - ELECTRICAL CONNECTIONS..........................................
6.0 - WIRING DIAGRAM.............................................................
7.0 - ENGINE IMMOBILIZATION CONNECTION DIAGRAM
(ground wire).......................................................................
8.0 - ENGINE IMMOBILIZATION CONNECTION DIAGRAM
(cut wire)...............................................................................
9.0 - EXAMPLE OF ENGINE IMMOBILIZATION CONNECTION
WITH SPECIFIC WIRING HARNESS....................................
10.0 - ELECTRIC AL CONNECTIONS WITH SPECIFIC
WIRING HARNESS............................................................
10.1 - Engine immobilization connections..................................
10.2 - Turn indicator connections...............................................
10.3 - Ground connection..........................................................
10.4 - Electronic key receptacle with built-in LED......................
11.0 - DIODE INSTALLATION.....................................................
12.0 - LEARNING NEW DEVICES (with ground wire)................
13.0 - LEARNING NEW DEVICES (without ground wire)...........
14.0 - PROGRAMMABLE FEATURES.......................................
15.0 - PROGRAMMING EXAMPLE
16.0 - MOTION SENSOR ADJUSTMENT
1.0 - PRELIMINARY ADVICE
Please read all instructions and understand them thoroughly before
starting installation.
Page 15
Page 15
Page 16
NO!
Page 17
Page 18
Page 18
Page 18
Page 19
Page 20
Page 21
Page 22
Page 23/24
Page 25
Page 25
Page 25
Page 25
Page 25
Page 26
OK!
Page 27
Page 28
Page 29/30
Page 31
Page 32
If a jet wash is used to clean the vehicle, protect the alarm unit from water
splashes and be careful not to expose it to high pressure jets.
The warranty will not cover damages to the system due to water infiltrations
caused by improper installation, jet washing or the use of non original
accessories, not approved by the manufacturer.
2.0 - ALARM UNIT POSITIONING
Do not install the alarm unit in this
position as water ingress over time
may seep through the rubber sheath
and permanently damage the
electronic circuit making the alarm
system unreliable.
Eventual malfunctioning due to
water infiltration is not covered by
warranty.
!
Fitt ing th e control unit in this position, will prevent
water entering the unit .
!
It is important to give the rubber sheath a 'goose-
neck' bending as shown in the picture opposite and
secure with a tie wrap.
!
Do not expose to atmospheric agents.
!
Pay attention not to muffle the siren speaker
!
Secure away from moving mechanical parts.
!
Keep away from devices that could generate high
frequency electromagnetic disturbances.
!
Keep away from devices that could reach high
temperatures when the vehicle is in use.
!
Do not secure t he control unit directly on the vehicle
frame.

CAUTION

.
Page 16