Programmable Features - Gemini 953 Installation And Use Manual

14.0 - PROGRAMMABLE FEATURES

To either enable or disable one of the programmable features proceed as shown
below:
NB: Remember to ALWAYS arm and disarm the alarm before programming.
1
With the alarm system disarmed, lift the
seat or open the topcase (if they are
protected by a contact switch) otherwise
ground the GREEN/BROWN wire.
2
Turn ignition key "ON".
3
The LED will light up for approx. 1".
4
While the LED is ON, simultaneously press
the 2 buttons on the remote control.
T wo beeps (a low and a high tone beep) will
confirm the system is in programming mode.
The LED will light up steady
Page 29
Remove from ground after
programming.
.
After pressing both buttons simultaneously (step 4), program the features
according to your needs.
TO ENABL E
Press button 1
Button N.1: ENABLE
ACOUSTIC SIGNALS
(enabled by Gemini)
Button N.2: DISABLE
Button N.1: ENABLE
PANIC SIREN
(enabled by Gemini)
Button N.2: DISABLE
Button N.1: ENABLE
MOTION SENSOR
(enabled by Gemini)
Button N.2: DISABLE
Button N.1: ENABLE
PASSIVE ARMING
(disabled by Gemini)
Button N.2: DISABLE
Button N.1: ENABLE
ANTI-HIJACK
(disabled by Gemini)
Button N.2: DISABLE
Button N.1: ENABLE
PRE-ALARM
(disabled by GEMINI)
Button N.2: DISABLE
Button N.1: ENABLE
SELF-REARMING
(Disabled by Gemini)
Button N.2: DISABLE
TO DISABL E
Press button 2
EXIT PROGRAMMING
Page 30