Programming Example; Motion Sensor Adjustment - Gemini 953 Installation And Use Manual

15.0 - PROGRAMMING EXAMPLE

To help you understand the programming procedure, here below is an
example showing how to activate the acoustic signals, the panic alarm, the
shock sensor and the pre-alarm features
Keep in mind that, at every button press, the system automatically scrolls to
the next feature .
!
With the system disarmed, l ift the seat or topcase (if protected by a
contact switch) otherwise ground the BROWN/GREEN wire
!
Turn ignition key "ON"; the LED will turn ON for 1"
!
While the LED is ON, simultaneously press the two buttons on the remote
control. Two beeps will confirm the system is in programming mode. The
LED will light up steady .
!
P ress button 1 a high tone beep will confirm acoustic signals have been ;
enabled .
!
P ress button 1 a high tone beep will confirm the panic siren has been ;
enabled .
!
P ress button 1 a high tone beep will confirm the motion sensor has been ;
enabled .
!
P ress button 2; a low tone beep will indicate passive arming has been
disabled .
!
P ress button 2; a low tone beep will indicate the
been disabled .
!
P ress button 1 a high tone beep will confirm ;
enabled .
!
P ress button 2; a low tone beep will confirm
disabled.
!
When the last feature has been enabled or disabled, the system
automatically exits the programming procedure. Two
followed by a high tone beep will confirm the end of the procedure. The
status LED will also turn OFF .
!
Turn ignition key "OFF". Close the topcase or seat or remove the
BROWN/GREEN wire from ground .
CAUTION
You can exit the programming procedure at any time by turning ignition
key "OFF".
Programmed features will automatically be saved while the others will
remain unvaried.
Page 31
.
.
.
anti-hijack feature has
pre-alarm has been
self-rearming has been
low tone beeps
16.0 - MOTION SENSOR ADJUSTEMENT
The alarm system has a built-in shock sensor with 5 levels of sensitivity
adjustment. T e shock sensor is factory preset to be at minimum sensitivity. h
To change the sensitivity level proceed as follows:
!
Disarm the alarm system via remote control or electronic key.
!
Turn ignition key "ON"; the status LED will turn ON for 1"
!
While the LED is ON, press remote control button 2 and, within 2", press it
again.
CAUTION
The procedure will be voided if more than 2 seconds go by between the
first button press and the second.
!
Two LED flashes and two low tone beeps will confirm the system has
entered adjustment mode.
!
Press remote control button 2 to increase sensitivity (press 4 times to set at
maximum level); there will be a LED flash and a short beep at every button
press.
!
When the sensor is adjusted, turn ignition key "OFF".
!
If adjusted at the highest level, the system automatically exits the procedure.
!
In both cases, a LED flash and a low tone beep will confirm the end of the
procedure.
CAUTION
Entering in programming mode resets features to factory default settings.
.
Page 32