Phoenix Contact FL WLAN 24 AP 802-11 User Manual page 76

Factory Line - Wireless LAN
WLAN 1/2
3-42
PHOENIX CONTACT
SNMP Community IP: Access with the specified community name is limited to the
following IP addresses.
To permit all source IP addresses, enter the IP "0.0.0.0".
SNMP Community network mask: Set the corresponding subnet mask here.
SNMPv3 username and encryption: This function is only available if SNMPv3 is selected.
User name/Password: Enter the user name and password for authentication. The
authentication protocol used is MD5.
Preshared Key: The pre-shared key (PSK) is a key, comprising letters and/or numbers,
which can be used in addition to the user name and password. The "Generate PSK" button
can be used to set a randomly generated numerical code, which can be used for the PSK.
Enable SNMP Trap Generation: When the SNMP trap function is enabled, event
messages (Link down/up, etc.) can be sent to a predefined trap receiver.
SNMP Trap Community Name: Enter the community name for traps here.
SNMP Trap Receiver IP: Enter the IP address of the trap receiver here.
3.5.4.5 "WLAN device/Security" menu
The use of encryption or authentication is specified here. The following options can be
selected:
The options are:
– Deactivated
– WEP 64 bits
– WEP 128 bits
– WPA/RADIUS
7190_en_02