Table of Contents
Advertisement
Factory Line - Wireless LAN
TFTP with the Factory
Manager
Table 3-2
Sequence of status and diagnostic indicators during the firmware update
Des.
Color
PWR
Green
POE
Green
Des.
Color
(LINK)
LINK/
Green
ACT
LINK/
-
ACT
LINK/
Green
ACT
3-26
PHOENIX CONTACT
5.
Enter the IP address of the server in the "Server address" field.
6.
Under "Filename and location", specify all subdirectories and the file name for the
firmware.
7.
Start the update.
As soon as the green "Link" LED for the port remains lit and the ACT LED goes out, click on
"Try to reconnect" to attempt to establish a new connection to the device.
If you want to use the Factory Manager as a TFTP server for a firmware update, please refer
to the important information provided in the application note below. Please note that the
Firmware update description differs from that in the application note, it can only be
activated by clicking on "Update now" in WBM.
To update with the Factory Manager, select the "TFTP" protocol. Under "Server IP address"
enter the address of the computer on which the Factory Manager is installed. For "Filename
and location", simply enter the file name of the new firmware file.
An application note for TFTP download (AH EN TFTP FIRMWARE UPDATE) can be
found at www.phoenixcontact.net/download.
Once the update has been started a new web page is generated first. This page contains a
link – "Try to reconnect". This link only works once the software update is complete.
Figure 3-27
Information displayed in WBM during the update
3.5.2.4
Sequence of status and diagnostic indicators during the update
Status
Meaning
ON
Supply via 24 V DC (230 V AC) present
OFF
Supply via 24 V DC (230 V AC) not present
ON
Supply via Power over Ethernet present
OFF
Supply via Power over Ethernet not present
Color (ACT)
Action
Orange
1. Both LEDs flash quickly
Orange
2. LINK LED goes out/ACT flashes
-
3. LINK lit/ACT goes out
7190_en_02
Advertisement
Table of Contents
