Table of Contents
Advertisement
SCANNER UNIT
3.3.5 SCANNER WIRES
• Move the first scanner next to the opening in the frame.
• Exposure glass (
• Lens cover (
3.3.2)
• Exposure glass bracket (
• Lower rear scanner frame, Upper rear scanner frame, Front scanner frame (
3.3.1)
1. First scanner ([1]: 2 pins)
NOTE: The drawings show only the front side. Repeat the procedure to
remove components on the other side.
[A]: Wire tension brackets (2 springs,
[B]: Scanner drive pulleys (2 Allen screws)
[C]: Scanner wires
Installation
1. Wrap the new scanner wire around the pulley as shown
secure the pulley with tape.
2. Re-install the 1
scanner positioning pins (P/N A0069104), as shown in the illustration on the
next page.
3. Wind the new scanner wire around the scanner drive pulley in the correct way,
as shown.
4. Wind the end of the new wire with the ball as shown ( ).
5. Wind the end of the new wire with the ring as shown ( ,
6. Connect the tension spring to the wire tension bracket ( ).
7. Wind the new scanner wire for the other side as well.
C262/C265
3.2.4)
3.3.1)
[1]
C262R010.WMF
ST
scanner. Then secure the first and second scanner with the
[A]
x 2)
3-10
[C]
[B]
C262R011.WMF
, then temporarily
, and
).
SM
Advertisement
Table of Contents
