Table of Contents
Advertisement
3) Then, with SP 2-10-1 to -4, you can specify the meaning of each of these 4
ID codes.
• 2-10-1 specifies the meaning of ID0
• 2-10-2 specifies the meaning of ID1
• 2-10-3 specifies the meaning of ID2
• 2-10-4 specifies the meaning of ID3
There are 15 possible colors that can be specified with SP 2-10-1 to -4.
0
1
Other
Red
8
9
Maroon Navy Orange Teal
Default: 0 (other)
For example, you install a drum with DPS 902-1 and -2 both set to OFF (this
means 'ID0'). If this drum contains blue ink, then set SP 2-10-1 to 2 (blue).
Then 'blue' will be shown on the display panel when this drum is installed.
The names in the above table are fixed in the software. So, for example, if
the drum contains gold-coloured ink, the selected color should be 14 (yellow
base).
11. Place the original on the exposure glass or ADF.
12. Make a master and make 30 prints with this master. Do this at least three times,
until the image quality is acceptable.
NOTE: This is a new drum. Because of this, before the first print is made, ink is
supplied automatically. This takes 2 minutes.
SM
Allocation of color codes
2
3
4
Blue
Green Brown
10
11
12
Red
Base
1-27
INSTALLATION PROCEDURE
5
6
Gray
Yellow
13
14
Blue
Yellow
Base
Base
7
Purple
C262/C265
Advertisement
Table of Contents
