Nikon EDG 85-A VR Instruction Manual page 17

VR (Vibration Reduction) function
1. Confirm that batteries are set in the battery holder
2. Turn the VR lock knob and align the index to the ○ position (Fig. 5)
3. Push VR ON/OFF button once to turn VR ON (green LED will light
up) (Fig. 6)
* VR ON/OFF button only works when the index of the VR lock knob is
aligned to the ○ position.
* VR turns off automatically after approx. 30 minutes of turning VR on (Auto
power off function).
* When using digiscoping, camera's VR setting must be turned off.
* Since the VR function of this product is designed on the premise of using
with a tripod, using one is recommended.
* When green LED does not light up, batteries are weak and should be
replaced.
Deactivate VR function:
Turn VR OFF by pushing VR ON/OFF button once. Then turn the index
of the VR lock knob to the "LOCK" position.
・ Make sure that the index of the VR lock knob is turned to the clicked ○
position before turning VR on. Never move the VR lock knob when VR is
on. If it is moved, VR function stops forcibly, and power turns off.
・ When transporting, make sure that the index of the VR lock knob is in
the locked position. If it is not locked, impact or dropping may cause
problems.
・ Remove the Fieldscope body from a tripod when transporting to avoid
accidental falling or other impact that may cause damage.
・ Do not remove the battery holder from the body when VR is on (when LED
is lit). This may cause problems.
・ Image moves slightly a few seconds after VR turns on, this is normal.
・ A driving sound is heard after VR turns on. This is normal.
VR lock knob
(Fig. 5)
(Fig. 6)
VR ON/OFF button
Green LED
when VR is on
En
Es
Fr
De
It
Se
Nl
Ru
Pt
Pl
Fi
No
Dk
Cz
Ro
Hu
17