Chapter 5:Installation And Setup; Chapter 6:Operation - Emerson Branson LPX Instruction Manual

1.2.3 Safe Operation
Setup and Operation instructions are found in
For safe operation, please ensure that all people using this equipment follow those
instructions and observe all CAUTION and WARNING notices.
Make sure that the equipment is properly grounded. DO NOT operate if it is not.
Periodically test the equipment as described in
CAUTION
NOTICE
Sound level and frequency of the noise emitted during the ultrasonic assembly process
may depend upon a. type of application, b. size, shape and composition of the material
being assembled, c. shape and material of the holding fixture, d. welder setup
parameters and e. tool design. Some parts vibrate at an audible frequency during the
process. Some or all of these factors may result in sound levels of over 80dB. In such
cases operators may need to be provided with personal protective equipment. See 29
CFR (Code of Federal Regulations) 1910.95 Occupational Noise Exposure. For all other
countries, follow your local regulations.
CAUTION
1.2.4 Setting Up the Workplace
Measures for setting up a workplace for safe operation of the ultrasonic welder are
outlined in Chapter 5: Installation and
100-412-196 REV. 06
Loud Noise Hazard
On certain applications, sound level emissions over 80dB have can be
generated. To prevent the possibility of hearing loss, use appropriate
hearing protection.
General Warning
Never touch the horn or tip when ultrasonics are active. Touching the
horn or tip while the unit is on can result in serious injury. When you
handle, remove, or attach a horn or tip, always make sure that the
ON/OFF switch on the back of the unit is set to OFF. See
Connections.
Setup.
Chapter 6: Operation of this manual.
4.2 System Performance Benchmark.
2.3 Back Panel
5