Attaching The Ap200 Antennas; Mounting The Access Point - Meru Networks ap150 Installation Manual

Attaching the AP200 Antennas

The AP200 is provided with external antenna ports. Make sure that all external antennas and their
associated wiring are located entirely indoors. The external antennas are not suitable for outside use.
If the AP200 does not have external antennas, attach the antennas to the connectors on the AP200 (see
Figure
should be finger-tight.
Caution!
before moving the antenna. Retighten the ring afterward. Otherwise, you might damage the internal
cabling in the AP.

Mounting the Access Point

You can mount an AP200 in the following ways:
Horizontally, as described in the
Vertically, as described in the
Below a hanging ceiling, as described in the
Above a tiled hanging ceiling, as described in the
section.
Horizontal Mounting
To horizontally mount an AP200:
1.
2.
5). Rotate the knurled ring at the base of the antenna clockwise to attach the antenna. The ring
When changing the orientation of the antennas, be sure to slightly loosen the knurled ring
Place the AP200 flat on the horizontal surface.
For each antenna, loosen the knurled ring at the base of the antenna (see
antenna straight up, then retighten the ring.
"Horizontal Mounting"
"Vertical Mounting" section.
"Mounting Below a Suspended Ceiling"
"Mounting Above a Suspended Ceiling"
Installing the Access Point
section.
Figure 5), point the
Installing the AP200
section.
11